Lbl-lighting MO Telescoping Rigid Standoff Bedienungsanleitung PDF herunterladen

Installation Instructions for

Telescoping Rigid Standoffs

1.3

HANGER-ADJ-_(-BJ)

980MRLTSP

Install the Ceiling Anchor

ANCHOR

GP I :ENERAL RODUCT NFORMATION

This product is suitable for dry locations only.

This product must be used with LBL Monorail systems only.

This instruction is for the following models:

Monorail Support 2.6" - 4" (HANGER-ADJ-_1)

Monorail Support 6" - 10" (HANGER-ADJ-_2)

Monorail Support 12" - 24" (HANGER-ADJ-_3)

Monorail Support 24" - 48" (HANGER-ADJ-_4)

Monorail Support 48" - 96" (HANGER-ADJ-_5)

Above model numbers with -BJ suffix (vaulted ceilings).

Select a location on the ceiling where the Monorail is to be

mounted.

One way of marking the standoff locations on the ceiling is to

lay the Monorail on the floor underneath of the selected

location and by using a plumb bob pointing on the center of

the Monorail, mark the points on the ceiling.

Another way is to hold the Monorail directly against the ceiling

and mark the standoff points on the ceiling.

Tap the anchors at the marked points up to the threaded

portion with a hammer.

Screw the anchors in the rest of the way with a Phillips

screwdriver.

Insert the #8 screw into the threaded nipple and washer.

Tighten the #8 screw completely into the anchor to secure the

washer and threaded nipple.

Repeat these steps for each standoff.

ANCHOR

WASHER

#8 SCREW

THREADED NIPPLE

CEILING

Monorail

1B1C

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Telescoping Rigid Standoffs

Installation Instructions forTelescoping Rigid Standoffs1.3HANGER-ADJ-_(-BJ)980MRLTSP1Install the Ceiling AnchorANCHORGP I :ENERAL RODUCT NFORMATIONTh

Seite 2

2Screw the support post completely to the threaded nipple.SUPPORT POSTTHREADED NIPPLEAttach the Telescoping StandoffAttach the Vault Adapter (Optional

Seite 3 - Install the Monorail

3Adjust Standoff Height (Optional)Slightly loosen the M3 set screw on the(Do Not Remove)side of the telescoping post with the 1.5 MM Allen wrenchprovi

Seite 4 - SAVETHESE INSTRUCTIONS!

3If necessary (Depending on design) rotate the Monorail to thedesired angle or horizontal position.Tighten the two M3 set screws on housing with the 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Lbl-lighting MO Telescoping Rigid Standoff Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Lbl-lighting MO Telescoping Rigid Standoff herunter. LBL Lighting MO Telescoping Rigid Standoff User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Lbl-lighting MO Telescoping Rigid Standoff