Lbl-lighting Vera S Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Lbl-lighting Vera S herunter. LBL Lighting Vera S User Manual [de] Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Installation Instructions for
Vera Suspension
1.0
980VERAS
Suspension
SU776_2D
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4” square electrical box with a
round plaster ring or an octagon electrical box.
This product is suitable for damp locations.
This product can be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1
Preparing the Canopy
2
1B
1A
Separate the mounting plate from the canopy by
completely unscrewing the strain relief.
1
STRAIN RELIEF
MOUNTING
PLATE
CANOPY
SET SCREW
Loosen the set screw on the strain relief.(Do Not Remove)
Install the fixture
NOTE: Make sure to support the fixture while
adjusting the aircraft cables. An assistant is
recommended to complete the remaining steps.
Feed the aircraft cable(s) through the cable clutch in the
canopy.
Evenly pull the aircraft cable up through the canopy to
raise the fixture to the desired length.
Cut off the excess aircraft cable leaving enough for fine
leveling later.
Feed the power cord from the fixture into the strain
relief and place it back into the canopy.
21
2
2
2
3
2
4
2A
CABLE
CLUTCH
AIRCRAFT
CABLE
STRAIN RELIEF
CANOPY
POWER CORD
3
1
SET
SCREW
4
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - Vera Suspension

Installation Instructions forVera Suspension1.0980VERASSuspensionSU776_2DGP I :ENERAL RODUCT NFORMATIONThis product can mount to either a 4” square el

Seite 2 - Install the Canopy

2NOTE: The power cord does not support the fixture.For a casual “lazy cord” look, cut the power cordseveral inches longer that the drop height of thef

Seite 3 - MAX 75 Watt

33D#8-32SCREWCROSSBARPlace all wires and wire nut connections properly insidethe electrical box.Secure the mounting plate to the electrical box with t

Seite 4 - (Optional)

4SAVETHESE INSTRUCTIONS!7400 Linder Ave, Skokie, IL 60077800.323.3226 - 847.626.6300www.lbllighting.com© 2014 LBL Lighting.All rights reserved.The &

Kommentare zu diesen Handbüchern

Keine Kommentare