Lbl-lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v Bedienungsanleitung PDF herunterladen

Installation Instructions for

12 Volt 150 Watt Single Power Feed

Magnetic Surface Mount Transformers

1.3

TRANS-SFM150-SC-LED

980MRLSFM15SMT-LED

GP I :ENERAL RODUCT NFORMATION

This product is ETL listed only when all the products used are

supplied by LBL Lighting, is suitable only for indoor dry locations

and approved for use at any height above the finished floor.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes.

This product may be dimmed only with a low voltage magnetic

dimmer. Using a dimmer not designed for low voltage magnetic

applications may cause undesirable noise and potentially shorten

the life of the transformer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

Read all instructions thoroughly. Read "Important Safety

Information" on next column before proceeding with the

installation.

Important Safety Information

Do not conceal or extend bus bar conductors through a building

wall.

Do not install this lighting system in a damp or wet location.

To reduce the risk of fire and burns, do not install this lighting

system where the uninsulated open bus bar conductors can be

shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a

fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains

or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in

any way.

The fixtures used with the system must be identified to be used

with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98

cubic centimeters).

Load the circuit of the surface mount transformer to no more than

the maximum rated capacity as specified.

LED-Illuminated Monorail

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Important Safety Information

Installation Instructions for12 Volt 150 Watt Single Power FeedMagnetic Surface Mount Transformers1.3TRANS-SFM150-SC-LED980MRLSFM15SMT-LED1GP I :ENERA

Seite 2 - Adjust the Power Feed Height

2Adjust the Power Feed HeightThe overall length of the transformer (from the top of thetransformer to the bottom of the power feed connector) is42&quo

Seite 3 - Install the LED Transformer

Install the LED TransformerCROSSBAR#8-32 FLATHEAD SCREWRemove the two #8-32 flat head screws to remove thecrossbar.#8-32SCREWCROSSBARMount the crossba

Seite 4 - SAVETHESE INSTRUCTIONS!

4SAFETY WIRECROSSBARBRACKETHook the LED transformer safety wire onto the crossbarbracket.Connect the crossbar green wire to the ground in accordancewi

Kommentare zu diesen Handbüchern

Keine Kommentare

Lbl-lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Lbl-lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v herunter. LBL Lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v User Manual [de] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Lbl-lighting LED Illum MO Surf Mag Xfmr 150w 120v/12v